Which statement describes dlci 17

Which statement describes DLCI 17? It cannot be used on R3 or R1. Answer: C Question 4 Users have been complaining that their Frame Relay connection to the corporate site is very slow.

The network administrator suspects that the link is overloaded. Based on the partial output of the Router show frame relay pvc command shown in the graphic, which output value indicates to the local router that traffic sent to the corporate site is experiencing congestion? All TCP traffic is marked discard eligible. All traffic exceeding the CIR is marked discard eligible. A show frame-relay pvc B.

Both routers are running IOS version Based on this information, what is the most likely cause of the problem? According to the topology, we can infer that the link between Router1 and Router2 is down.

What is needed to allow communication between the VLANs? Different VLANs can't communicate with each other, they can communicate with the help of Layer3 router. Hence, it is needed to connect a router to a switch, then make the sub- interface on the router to connect to the switch, establishing Trunking links to achieve communications of devices which belong to different VLANs. End user devices connect to switch ports that provide simple connectivity to a single VLAN each.

The attached devices are unaware of any VLAN structure. By default, only hosts that are members of the same VLAN can communicate. To change this and allow inter-VLAN communication, you need a router or a layer 3 switch. An administrator pings the default gateway at At which OSI layer is the problem? The command ping uses ICMP protocol, which is a network layer protocol used to propagate control message between host and router. The command ping is often used to verify the network connectivity, so it works at the network layer.

What will be the result if the following configuration commands are implemented on a Cisco switch? A: Configure a separate sub-interface for each PVC with a unique DLCI and subnet assigned to the sub-interface B: Configure each Frame Relay circuit as a point-to-point line to support multicast and broadcast traffic C: Configure many sub-interfaces on the same subnet D: Configure a single sub-interface to establish multiple PVC connections to multiple remote router interfaces Correct Answer: A Explanation: Look at the figure below: www.

Complete the topology. Category: Documents. Exam Preparation Questions Category: Documents. Category: Technology. Size px x x x x Modal title. Close Save changes. New Message. Select: Alaska 2 3 4 5. Close Save message. User Name:. UseSSH anotherencrypted authenticatedtransport accessdevice configurations. Answer: BD Which two packets, denied?

Refer exhibit. Switch1 has just been restarted haspassed POSTroutine. Host sendsits initial frame firstthing regardspopulating switchingtable? E switchingtable. What twosecurity appliances network? What mostefficient summarization R1can use advertiseits networks Which spread spectrum technology does Assume allrouter interfaces correctlyconfigured. How defaultroute configured R1affect Anypacket destined directlyconnected routerR1 Anypacket destined directlyconnected routerR2 droppedimmediately.

Anypacket destined directlyconnected routerR2 droppedimmediately because networksdirectly connected routerR2 Anypacket destined routingtable routerR2 R1. R1 packetback routingloop occur.